ACTiSYS IrDA

Pēc lielas čakarēšanās ap šo dzelzi tapa šis doķis.
Te ir info kā pārlikt vadus citā štepselī un ko ieslēgt BIOSā.
Uz minētās SOYO pāksnes viss ir OK, uz Shuttle konekts brīžiem pārtrūkst nezinu kapēc :-(

ACT-IR210L
(Tas ir uz motherboard spraužams.)
ACT-IR210L only supports IrDA standard 1.0, the speed up to 115.2kbps
On ACT-IR210L side, the pin assignments are: 
Green-IRTX, Yellow-IRRX, Black-GND, Red-VCC. 

Connetor:
 - green   TX
 - black   GND
 - yellow  RX
 - ≤none>
 - red     +5V

OK with:
SOYO6BA+III
SOYO6BA+IV


Shuttle MV25/MV25N

      Key GND  RX
       2   4   6
     -------------
     |   | o | o |
     |-----------|
     | o | o | o |
     -------------
       1   3   5
      NC  +5V  TX


Būtisks info: (http://www.actisys.com/ts210l.html)
Motherboard information for ACT-IR210L For Bios Settings

Select "Integrated Peripherals" or "Chipset Features" in the system Bios setup. 
Onboard UART1(Com1, Seral Port 1 ): 3F8H/IRQ4
Onboard UART2(Com2, Seral Port 2 ): 2F8H/IRQ3 
Onboard UART2 mode: IrDA (or HPSIR; don't choose ASK) 
IR Duplex mode: Half (If BIOS has this option) 
Tx/Rx Active: Hi/Lo or No/Yes (If BIOS has this option) 
IR Transmission delay: Enable (If BIOS has this option) 

Make sure the Microsoft infrared Communication Driver 2.0 has been installed correctly on the system. If the driver needs to be reinstalled, please remove the previous one, first, through Add/Remove Programs in Control Panel. 
During setup the driver, the "Built-in Infrared Port on Laptop or Desktop" in "Standard infrared devices" should be selected for the hardware type. Do not select any hardware type under "ACTiSYS" for ACT-IR210L.